Thread: Ugh...PWM pin vs. Speed Controller
View Single Post
  #2   Spotlight this post!  
Unread 24-06-2002, 00:27
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: Ugh...PWM pin vs. Speed Controller
Posted by Thomas A. Frank at 2/9/2001 5:20 PM EST


Engineer on team #121, The Islanders/Rhode Warrior, from Middletown (RI) High School and Naval Undersea Warfare Center.


In Reply to: Ugh...PWM pin vs. Speed Controller
Posted by Eric Reed on 2/7/2001 6:54 PM EST:



: Man oh man. We have snapped off a PWM pin inside a speed controller. Any hope of getting it out? Any ideas about preventing this in the future?


If there is nothing sticking up above the level of the plastic, you are in tough shape.

What I have done in the past is to very carefully trim away enough of the plastic around the pin to get enough access to pull out the stub with some VERY sharp tweezers.

Or you could send the VICTOR back to Innovation FIRST to have them replace the connector.

In the future, loop the wire back around to the chassis, and attach it to a cable tie anchor, so that if the lead gets yanked, the force is taken up by the cable, not the connector.

For prototypes, I duct tape the cable down to the deck next to the VICTOR...usually after I damage the first one for the year.

Tom Frank


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.