Thread: brush transfer
View Single Post
  #2   Spotlight this post!  
Unread 24-06-2002, 00:27
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: brush transfer
Posted by Nate Smith at 2/7/2001 8:32 PM EST


Other on team #66, GM Powertrain/Willow Run HS, from Eastern Michigan University and GM Powertrain.


In Reply to: brush transfer
Posted by Sharif Mukhashen on 2/7/2001 6:57 PM EST:



: we would like to know if we can install an electrical brush system to transfer current from the power wire to the fisher price motors that we are using for our drive. this would be helpful to us in order to allow full 360 degree rotation on our wheels.

FIRST is kinda picky about what you can and can't use for electrical systems...look at the following points:
- Update 6, Q155
- Update 5, Q83
- Update 1, Q6
- Also, look at the Additional Hardware List(AHL)

In a nutshell, my reading of the rules(mainly in the updates) is that if you buy your "brush system" off-the-shelf and not fabricate it yourself, AND if it has the proper insulation on any non-contact surfaces, then you can use it. One alternative that you might want to consider is using a piece of tubing for the "axle" on which the 360 degree rotation is taking place, and running the wires through the center of the tubing. It doesn't completely eliminate the twisting, but it greatly reduces it...

Nate
__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.