Check out this thread here
http://www.chiefdelphi.com/forums/sh...938#post785938
it discusses what error 60 means
Quote:
Error 60 is listed as network address is currently in use. Troubleshooting the network stuff isn't my forte, but maybe that helps you.
Here are other procedural things that have helped other teams in the past.
Hook the cRIO directly to the PC, not through the DS, router or any sort of switch.
Turn off firewalls.
Turn off other enet cards, wifi cards, and other things that could confuse the routing as the cRIO IP moves around during the formatting process.
Try the formatting on anther computer (typically the failure was due to one of the previous two, and sometimes this is easier).
Pay careful attention to the DIP switches. Flipping them on to get the cRIO IP reset may then cause problems as you try to reimage.
Greg McKaskle
|
Oh yeah, so far I have recommended switching to another computer more than once and it has resolved issues. So you can always give that a try.