Thread: We NEED 8-inch wheels and programming help
View Single Post
  #2   Spotlight this post!  
Unread 24-06-2002, 00:29
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: We NEED 8-inch wheels and programming help
Posted by Matt Leese at 2/8/2001 5:21 PM EST


Other on team #73, Tigerbolt, from Edison Technical HS and Alstom & Fiber Technologies & RIT.


In Reply to: We NEED 8-inch wheels and programming help
Posted by Dan Rich on 2/8/2001 4:34 PM EST:



Ok, first of all, to get more wheel chair wheels call Skyway. Their contact information is in the manual under the supplier contact. They know about FIRST and are more than willing to help. They are however based in CA and unless you red label it, it will take awhile to get to you. To control two motors separately (we'll assume you're using a speed controller on them) with one joystick, assign the input (Y1, X1, etc.) to the PWM output you want to use.

Matt
__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.