Thread: We NEED 8-inch wheels and programming help
View Single Post
  #4   Spotlight this post!  
Unread 24-06-2002, 00:29
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: We NEED 8-inch wheels and programming help
Posted by Matt Leese at 2/8/2001 8:02 PM EST


Other on team #73, Tigerbolt, from Edison Technical HS and Alstom & Fiber Technologies & RIT.


In Reply to: Re: We NEED 8-inch wheels and programming help
Posted by Stephen on 2/8/2001 6:57 PM EST:



That will allow two motors to be controlled relative to the joystick position in BOTH the X and Y axis. That will NOT do what they asked for. What was asked for was basically this:
PWM1=p1_y
PWM2=p1_x

Matt who's coming closer and closer to deciding to write a Programming HOWTO for next year because they're are so many simple questions posted here.....

__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.