Thread: We NEED 8-inch wheels and programming help
View Single Post
  #8   Spotlight this post!  
Unread 24-06-2002, 00:29
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: We NEED 8-inch wheels and programming help
Posted by Joe at 2/9/2001 5:09 PM EST


Student on team #506 from St. Anthony's HS.


In Reply to: We NEED 8-inch wheels and programming help
Posted by Dan Rich on 2/8/2001 4:34 PM EST:



: Hey everybody. I'm from Team 550 in NJ, and we need a couple more 8 inch wheels. Anybody know where to get them? We would also like some help in getting two motors seperately controlled by one controller, one on the x-axis and one on the y-axis. Thanks.

PWM port # what controlls it
1 joystick 1 y_axis
2 joystick 2 y_axis
3 joystick 3 y_axis
4 joystick 4 y_axis

5 joystick 1 x_axis
6 joystick 2 x_axis
7 joystick 3 x_axis
8 joystick 4 x_axis

9 joystick 1 wheel
10 joystick 2 wheel
11 joystick 3 wheel
12 joystick 4 wheel

hope this helps. someone correct me if i'm wrong


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.