Quote:
Originally Posted by s1900ahon
Per <R60> if you want to wire the Brake/Coast Jaguar input, you must do so directly to the Digital I/O of the DSC. In this case, you should use a SINGLE wire between the signal of the DSC and the middle pin of the CB header (and only a single wire). To connect any other wire invites shorting unequal voltage sources or introducing additional current return paths.
|
I had assumed we would need both 0v and signal to the CB port due to the optical isolation of the PWM input, which also appears to be the wiring shown on the Jaguar Getting Started guide. However it also states that all other (i.e. non-PWM) connections are referenced to power ground.
Thanks for the suggestion.