Thread: Don't tell me nobody's had this problem...
View Single Post
  #2   Spotlight this post!  
Unread 24-06-2002, 00:32
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: Don't tell me nobody's had this problem...
Posted by Michael Betts at 2/9/2001 11:18 AM EST


Engineer on team #177, Bobcat Robotics, from South Windsor High School and International Fuel Cells.


In Reply to: Don't tell me nobody's had this problem...
Posted by Eric Reed on 2/9/2001 10:07 AM EST:



: Hi,

: I posted a message a couple days ago because we snapped a pwm pin off inside our speed controller. I know somebody out there has had this happen, because it happens so easily. But nobody replied! Does this mean there is no solution? Do we have to shell out a bill and a half for a new speed controller because of a silly little scrap of copper? Can't be! Some brave roboteer out there has the answer! I just know it! I just know it!

: Eric...losing it
: Team 481

Eric,

We have never had this problem. I suggest you contact InnovationFIRST and let them talk you through the problem.

Mike



__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.