Thread: steel plate ........legal dimensions?
View Single Post
  #2   Spotlight this post!  
Unread 24-06-2002, 00:32
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Yes, 3/8" is OK, as long as you buy from SPI
Posted by Andy Baker at 2/9/2001 12:26 PM EST


Engineer on team #45, TechnoKats, from Kokomo High School and Delphi Automotive Systems.


In Reply to: steel plate ........legal dimensions?
Posted by S. Krussell on 2/9/2001 12:02 PM EST:



Susan,

Yes, you can use 3/8" steel plate. You just gotta order it from SPI.

You can also get some other sizes of steel out of the rods and bar stock that SPI provides, but the types of steel are slightly different in the various sizes.

For instance, cold rolled steel can be purchased in 3" round stock, but you can only get ground tool steel in 2" stock.

Andy B.


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.