Thread: operator interface board
View Single Post
  #2   Spotlight this post!  
Unread 24-06-2002, 00:33
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: operator interface board
Posted by Matt Leese at 2/9/2001 5:12 PM EST


Other on team #73, Tigerbolt, from Edison Technical HS and Alstom & Fiber Technologies & RIT.


In Reply to: operator interface board
Posted by Stephen on 2/9/2001 5:08 PM EST:



Try using a polycarbonate mounting system. Last year we had a little box that folded up. You had to remove the joysticks but otherwise the whole thing worked very well. You just have to make it no larger than 1'x3'. The advantage of it closing up is that it protected the whole thing from getting bumped around or whatnot. BTW, I was on team 7 at the time....

Matt

__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.