Thread: Need help in creating program to use servo's to shift drive
View Single Post
  #10   Spotlight this post!  
Unread 24-06-2002, 00:34
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Yep, something like that
Posted by Andy Baker at 2/10/2001 11:24 PM EST


Engineer on team #45, TechnoKats, from Kokomo High School and Delphi Automotive Systems.


In Reply to: you need more than that...
Posted by Joe Johnson on 2/10/2001 11:05 PM EST:



: Something like: Stop. partial forward, partial backard,
: shift, partial forward, partial backward. Continue.

: Basically, you have to take the stress out of the
: mechanism to get it to shift out of gear and then you
: have to wiggle it to get it to fully engage in gear.

Yes, I believe that's how we do it.

BUT, I do not know the code. Our software guys don't let me near the keyboard.

We've refined it down to the point where it takes under two seconds.

Andy B.


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.