Thread: Need help with custom switches
View Single Post
  #2   Spotlight this post!  
Unread 24-06-2002, 00:35
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: Need help with custom switches
Posted by Nate Smith at 2/10/2001 2:58 PM EST


Other on team #66, Frostbite, from Willow Run High School and GM Powertrain.


In Reply to: Need help with custom switches
Posted by Michael Bloomfield on 2/10/2001 11:13 AM EST:



: Hey...need some help with custom switches. We are making the Operator Switch Box but I can't seem to find the pinout chart for where the 3 wires go. I know that we gotta plug it into Port 3 or 4 cause using P1 and P2 for joysticks. Does anyone know where I can find a pinout chart for switches. Thanks.

If you download the control system manual from www.innovationfirst.com, the pinouts for all four ports are there...

Nate
__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.