Thread: Drill Mounting
View Single Post
  #2   Spotlight this post!  
Unread 24-06-2002, 00:39
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: Drill Mounting
Posted by Matt Leese at 2/11/2001 3:55 PM EST


Other on team #73, Tigerbolt, from Edison Technical HS and Alstom & Fiber Technologies & RIT.


In Reply to: Drill Mounting
Posted by Dan Richards on 2/11/2001 2:58 PM EST:



I'm assuming you cut off the handle of the drill then.
You'll want to build some sort of mounting bracket for
the drill then (if you have someone skilled in sheet
metal this is their time to shine). It can take a
generic U shape sized for the drill and then just but
some sort of strap to hold it down. You can see some
pictures of what we've done on our website below.

Matt


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.