Thread: Drill Mounting
View Single Post
  #3   Spotlight this post!  
Unread 24-06-2002, 00:39
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: Drill Mounting
Posted by Alan Federman at 2/11/2001 8:52 PM EST


Engineer on team #255, Odyssey, from Foothill HS, San Jose and NASA.


In Reply to: Re: Drill Mounting
Posted by Matt Leese on 2/11/2001 3:55 PM EST:



: I'm assuming you cut off the handle of the drill then.
You can use the drill housing - Sligthly enlarge the screw holes in the case - Then use either dry wall screws into plywood or bolt through to aluminum plate -
1/4 inch or so - you also can reinforce with shims or
pillowblocks cut out of wood, plastic or aluminum.

Good luck.
__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.