Thread: Lifting the bridge...?
View Single Post
  #3   Spotlight this post!  
Unread 24-06-2002, 00:40
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: Lifting the bridge...?
Posted by Andres Teene at 2/12/2001 4:45 PM EST


Engineer on team #159 from Poudre High School and LSi Logic.


In Reply to: Re: Lifting the bridge...?
Posted by Matt Leese on 2/11/2001 9:13 PM EST:



Which motor are you using? We tried that with a 30" arm attached to the van door motor and it didn't have enough power to lower the bridge.

Andres


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.