Thread: Lifting the bridge...?
View Single Post
  #8   Spotlight this post!  
Unread 24-06-2002, 00:41
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Save those parts for the Hampster Playground!!
Posted by colleen - T190 at 2/13/2001 8:55 PM EST


Engineer on team #190, Gompei, from Massachusetts Academy of Math and Science and WPI.


In Reply to: 3 lbs over weight -- going on diet... ...again!
Posted by Joe Johnson on 2/12/2001 10:10 AM EST:



Hey Joe--

If you got that sprocket that wasn't made correctly.. don't fear!! it can be put to good use-- donate it to the Hampster Playground!!

That's how the playground got initiated... did you ever know the difference between a press fit and spinning freely is only about 1/100 of an inch.. Timmy found that out!! And thus unto us the Hampster Sit 'n Spin was born!

And slowly but surely the playground expands... we even have a Slip 'n Slide that used to be one side of our arm...

So don't throw them away.. donate to the playground.. the hampsters will love!

Happy dieting!!
__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.