Thread: Pneumatics Help!
View Single Post
  #1   Spotlight this post!  
Unread 24-06-2002, 00:45
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Pneumatics Help!
Posted by Elaine at 2/12/2001 9:01 PM EST


Student on team #368, Kika Mana, from Mckinley High School and NASA Ames/Hawaiian Electric /Weinberg Foundation.



Hi, I was wondering if any of the teams out there could help us. Our question is that in the pneumatics manual under flow controls, it says that you always mount a flow control into the porst of the cylinders before you hook up the tubing. But in team update number three, it says that you can only use the pneumatics that are given to us in the kit with exception to the cylinders. Our question is... since only six flow control valves are given to us, how are we suppose to hook up four or more cylinders to our robot. Right now we are using two flow controls per cylinder, one on each side... are we suppose to use only one?

Elaine
Kika Mana


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.