Thread: Shaft Couplings
View Single Post
  #7   Spotlight this post!  
Unread 24-06-2002, 00:46
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: Shaft Couplings
Posted by Matt Leese at 2/12/2001 10:17 PM EST


Other on team #73, Tigerbolt, from Edison Technical HS and Alstom & Fiber Technologies & RIT.


In Reply to: Shaft Couplings
Posted by Andy Grady on 2/12/2001 9:25 PM EST:



Ours have been working fine even though our drive train is slightly misaligned (we know about it, we're just not fixing it until we take apart the robot, paint it, and put it back together). We also are planning to use the keyway slot in the shaft. Are you having problems?

Matt
__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.