Thread: Shaft Couplings
View Single Post
  #9   Spotlight this post!  
Unread 24-06-2002, 00:46
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: We broke one!
Posted by Ken Leung at 2/13/2001 6:10 AM EST


Student on team #192, Gunn Robotics Team, from Henry M. Gunn Senior High School.


In Reply to: We broke one!
Posted by Andy Baker on 2/12/2001 11:19 PM EST:



HA! I was right about how those couplings will break because of those screws on the side.

Enough of that, can I ask a question?

What makes your team decide not to use Dr. Joe's drill output shaft? I mean, what factor influenced you and your team to attach the drill motor shaft couplings? And,

I don't remember if I asked this before... I am so tired from sitting in front of a new Bridge Port milling machining watching the auto feed mill out 2 feet of 1.25" x 1.25" Aluminum into .75" x .75" for 12 hours straight. zzz...zzz... Good thing a student came to me at the end and talked me out of my sleepiness.



__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.