Thread: Shaft Couplings
View Single Post
  #12   Spotlight this post!  
Unread 24-06-2002, 00:46
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
we're off by 2 degrees :)
Posted by Anton Abaya at 2/13/2001 12:14 AM EST


Coach on team #419, Rambots, from UMass Boston / BC High and NONE AT THE MOMENT! .


In Reply to: Shaft Couplings
Posted by Andy Grady on 2/12/2001 9:25 PM EST:



: Hello,
: Has anyone experienced problems with the special SPI made drill motor shaft couplings?
: Thanx,
: Andy Grady

well, given that we can catch air over the ramp and have made wicked cool maneuvers, and the fact that we are misaligned and have been abusing them, they've stood up pretty darn well.

screws are tight, keyway has never come loose and chains are a little too tight, but those babies have held up....

so far so good. how'd urs break exactly?

-anton
__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.