Thread: Organizing Tips?
View Single Post
  #2   Spotlight this post!  
Unread 24-06-2002, 00:46
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: Organizing Tips?
Posted by Ellery at 2/13/2001 12:16 PM EST


Engineer on team #191, X-CATS, from Joseph C. Wilson High School, Rochester NY and Xerox Corporation.


In Reply to: Organizing Tips?
Posted by Anton Abaya on 2/13/2001 1:13 AM EST:



What we've always done have been keeping a multi-chambered kit for standard fasteners and use only those in the design. As for the tools - bring a large toolbox with alittle of everything from basic drivers , taps,allen wrenches(english and Metric sets) lubricants, cordless drills,Files, vice,etc. but as for drill bits and taps stick to the standards - for example 1/4-20, metric(4-40,8-32,10-32), screws (sizes from 1/2"-2&quot, and nuts, lockwashers, and flat washers; also bring taps & drill bits( clearance & Tap) for all those sizes.

Spare parts for all damage prone parts are all stored in totes per subsystem (ie. drives, elevation, acquisition)


Hope this gives you an idea.

Ellery
__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.