Thread: Pot Gyro
View Single Post
  #1   Spotlight this post!  
Unread 24-06-2002, 00:47
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Pot Gyro
Posted by Jason294 at 2/13/2001 11:36 AM EST


Other on team #294, Beach Cities Robotics, from Mira Costa and Redondo Union and TRW.



Just wondering if anyone had fooled around with this idea. I attached about a 4 inch long piece of aluminum bar with a small weight on the end to a pot and used the feed back as a good gyro that dosent tax the robot controller like the quartz gyro with the kit. Anyone working on differant algorithims to auto-balance the ramp... I know im close, just wondering if you guys had thought of this. I'm sure it will be helpfull to someone. If u want to contact me e-mail Jason@DigitalAftertime.com


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.