Thread: coding, motors, spikes, help
View Single Post
  #3   Spotlight this post!  
Unread 24-06-2002, 00:48
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: coding, motors, spikes, help
Posted by Matt Leese at 2/13/2001 6:20 PM EST


Other on team #73, Tigerbolt, from Edison Technical HS and Alstom & Fiber Technologies & RIT.


In Reply to: Re: coding, motors, spikes, help
Posted by Kai Zhao on 2/13/2001 5:58 PM EST:



: :1) Can the Van Door motor be run from a toggle switch? It requries a speed controller, correct?

: Yes and no. Yes its possible but it is not allowed.

Actually, this is a definite Yes. You can run the Van Door from a toggle switch and it is legal. You do however need to use a speed controller with it. This takes a slight modification of the program but I'm sure that you can easily figure out how to do it.

Matt
__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.