Thread: Drill Motor Connections
View Single Post
  #1   Spotlight this post!  
Unread 24-06-2002, 00:48
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Drill Motor Connections
Posted by Alex at 2/13/2001 8:51 PM EST


Student on team #375, Robotic Plague, from Staten Island Technical High School and Verizon.



How are people connecting wires to the dril motor....we soldered them but they keep falling off.....any suggestions????

Thanks
Alex
Team 375


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.