Thread: Drill Motor Connections
View Single Post
  #4   Spotlight this post!  
Unread 24-06-2002, 00:48
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
offering a different solution.
Posted by Anton Abaya at 2/14/2001 12:39 AM EST


Coach on team #419, Rambots, from UMass Boston / BC High and NONE AT THE MOMENT! .


In Reply to: Drill Motor Connections
Posted by Alex on 2/13/2001 8:51 PM EST:



: How are people connecting wires to the dril motor....we soldered them but they keep falling off.....any suggestions????

: Thanks
: Alex
: Team 375

i agree with joe, you should solder and make sure u are using solder with that flux stuff on it so that it sticks. try sanding the tips of the motor's terminals with sandpaper as well before soldering.

if that doesnt work still, the female spade connectors (stake ons? is another term for it i think) and they plug in well. i'd be a little careful though just in case they fall for any reason at all.

good luck.

-anton
__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.