Thread: Drill Motor Connections
View Single Post
  #5   Spotlight this post!  
Unread 24-06-2002, 00:48
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: Drill Motor Connections
Posted by Stephen at 2/14/2001 7:18 AM EST


Other on team #122, NASA Knights, from Grafton High School (Robotics team is at NHGS) and NASA.


In Reply to: Drill Motor Connections
Posted by Alex on 2/13/2001 8:51 PM EST:



We have always used spade connectors, but you have to make sure that you crimp them well.

: How are people connecting wires to the dril motor....we soldered them but they keep falling off.....any suggestions????

: Thanks
: Alex
: Team 375


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.