Quote:
Originally Posted by GunfighterJ
How do you wire the voltage sensor to the cRIO analog sensor input?
|
Voltage sensor? If you are talking about how to setup/activate the battery voltage monitoring capabilities built into the Analog breakout board then the information you are looking for is on page 21 and 22 of Chapter 3 of the
Control System Manual.
You will need to install a jumper on some of the pins of the Analog Breakout board connected to the module in Slot 1 of your cRIO.
Since it is
CRITICAL that at least one person on your team and preferably all of your electrical and programming members read the documentation regarding the new control system I will not cite the exact procedure here.
If you have further questions after referencing the documentation I referred to then feel free to ask them here.