Thread: SPI Wheel coupling cracking like crazy!
View Single Post
  #2   Spotlight this post!  
Unread 24-06-2002, 00:56
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: SPI Wheel coupling cracking like crazy!
Posted by Matt Leese at 2/15/2001 7:59 PM EST


Other on team #73, Tigerbolt, from Edison Technical HS and Alstom & Fiber Technologies & RIT.


In Reply to: SPI Wheel coupling cracking like crazy!
Posted by Eric Reed on 2/15/2001 7:36 PM EST:



Plastics and locktight don't tend to mix well. I think someone already mentioned this problem. I would definately recommend using your own hardware for the wheel hubs. I also recommend making your own spacer (polycarbonate works well for that). Otherwise, just be careful with them.

Matt
__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.