Quote:
Originally Posted by The Megan 2207
I was working with this today and I found out that (on the joysticks that came with the KoP) axis 1 is the x-axis, axis 2 is the y-axis, and axis 3 is the throttle (the dial at the base of the joystick). As for the buttions, I know they're numbered but I'm not sure if those numbers match the button numbers in Labview. I do know that button 1 is the trigger, though. I hope that helps!
|
That did help as the trigger is wxactly what
I was looking for.. don't know about OP tho...
However, I still can't figure out how to wire the button out to say, a motor, so that when that button is pressed it activates that motor... well wait.. with what I had before (where the buttons are put in the front panel) it wouldn't let me wire out... but when I do the actual buttons it does... I'm not making sense, am I.