Thread: Drill motor copper electrical connector
View Single Post
  #1   Spotlight this post!  
Unread 24-06-2002, 00:57
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Drill motor copper electrical connector
Posted by Patrick Dingle at 2/16/2001 12:26 AM EST


Coach on team #639, Red B^2, from Ithaca High School and Cornell University.



Today at some point one of our drill motor electrical connectors fell off... We had the wire shrink-wrapped and soldered on, but the copper ripped where the hole was in the middle, giving us only a few millimeters of copper sticking out of the motor.

Anyone have any suggestions? We have no spares.

Thanks
Patrick


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.