Thread: Rookie Question. double solenoids...
View Single Post
  #2   Spotlight this post!  
Unread 24-06-2002, 00:57
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
burning smells are not usually good
Posted by Joe Ross at 2/16/2001 4:43 AM EST


Engineer on team #330, Beach Bot, from Hope Chapel Academy and NASA/JPL , J&F Machine, and Raytheon.


In Reply to: Rookie Question. double solenoids...
Posted by Anton Abaya on 2/16/2001 1:44 AM EST:



: we are trying to hook up the double solenoid to ONE Spike. i dont know electrical stuff (deprived i know) and let some1 else do it (for once). we tried it and we smelt something burning (on the solenoid) so we turned it off.

: we did it exactly the way the manual says we should do it with the diodes and all....

: did anyone else do this? or should i just go get a darn spike?

: and if i just use another spike, can i use last year's?

I'm not sure what you might have done ;-) My first thought was that you inserted a diode backwards, but if that were the case the solenoid probably wouldn't have worked, but shouldn't have burned. There was probably a short somewhere, thats the only thing that I can think of that might cause burning.

The simplest solution (unless you want to try it with the diodes again) would be to use 2 spikes. You are allowed to use spikes from last year. This does assume that the double solenoid still works.


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.