Quote:
Originally Posted by iCurtis
We found out on Saturday that 10% is pretty tight, and you can safely get away with much less. We had round belting on 3" diameter PVC rollers with grooves laid in for the belting to follow. These rollers were mounted on 1/2 steel shafts in plywood "bearings." The plywood supports were about 25" apart. Four urethane belts at 10% did a number of the shafts. We could clearly see the shafts bowing, and our 18V Dewalts had a hard time turning the assembly. To alleviate some tension, we moved the rollers closer together. The distance around the rollers was originally measured at 55 inches (so we cut the belts to be 49.5" long. We moved the rollers a good 2" closer, and found the belts were still taut, and had no problems with belts slipping, even when we jammed in seven balls and put a board across the top opening.
In short, we found cutting the cord at 10% shorter to be pretty aggressive. At 3% shorter (instead of 10%) the balls moved just as well, and the whole assembly ran much smoother.
Art, is there any reason for the half hour cure time? After five minutes or so ours were cool to the touch, and we haven't had any fail that were joined using your welding method.
|
10% is a total flat out lie on McMaster's part.
In 06 we used 5/16" clear urethane belting (solid core) and ordered the recommended 10% short. It was near impossible to get them onto our rollers. The process we had to go through to do it was so jerry-rigged and dangerous that I won't even describe it here. Not to mention the fact that once it was on, the efficiency of the entire system was horrid.
I'd recommend more like 3-5% stretch for anyone else who hasn't joined their belts yet.