Thread: Round Belting - Solid vs. Hollow, Polycord vs. McMaster
View Single Post
  #11   Spotlight this post!  
Unread 18-01-2009, 19:06
Bruceb's Avatar
Bruceb Bruceb is offline
Registered User
FRC #0706 (Cyberhawks)
Team Role: Mentor
  
Join Date: Jan 2008
Rookie Year: 2004
Location: Merton, wi
Posts: 615
Bruceb is a splendid one to beholdBruceb is a splendid one to beholdBruceb is a splendid one to beholdBruceb is a splendid one to beholdBruceb is a splendid one to beholdBruceb is a splendid one to beholdBruceb is a splendid one to behold
Re: Round Belting - Solid vs. Hollow, Polycord vs. McMaster
BTW.. I just got done making 10 belts from 1/4 round solid urethane(orange) belting 10 percent short. They are tight but running on half inch steel shafts 10 inches long and in bearings they seem fine.
Bruce