Thread: Assigning Joystick buttons....
View Single Post
  #3   Spotlight this post!  
Unread 24-06-2002, 00:59
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: Assigning Joystick buttons....
Posted by Elliot Johnson at 2/17/2001 1:34 AM EST


Student on team #218, HP Robotics Team, from Highland Park High School and Double-E Inc..


In Reply to: Assigning Joystick buttons....
Posted by Bradford Stephens on 2/16/2001 9:36 PM EST:



:what pins do I put them on and how do I read the pin :states?...

Check the control system manual at www.innovationfirst.com
It provides lists of which pins do what on the four joystick ports. To add more switches, you solder the wires to correct pins on one of the 15 pin connectors in the kit. The pinout lists also identify which variable to use to read the switches.

later,
Elliot


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.