|
Re: pic: Ball Harvester
Quote:
Originally Posted by falconmaster
Well we feel that we will be allowed with our bumper design. W willadd bumpers to the diagonal sections with 6 inch sections. If we are not allowed we will swap them out with a straight six inch sections. Our argument though will be that the corners will be protected, no bumper section will be less than 6 inches and the weight of the part not on the bumper perimeter will be counted against the robot weight. Even if you had a straight section instead of diagonals the corners would not be protected on the inside. Oh well we will see
|
Wow I think you are taking a big chance.
If I were your inspector I would rule that your angled bumpers do not qualify as BUMPERS.
__________________
"Champions are champions not because they do anything extraordinary but because they do the ordinary things better than anyone else." —Chuck Knoll
2015 Indianapolis District Winner
2014 Boilermaker Regional Industrial Design Award
2013 Smoky Mountain Regional Industrial Design Award
2012 Boilermaker Engineering Excellence Award
2010 Boilermaker Rockwell Innovation in Control Award.
2009 Buckeye J&J Gracious Professionalism Award
2009 Boilermaker J&J Gracious Professionalism Award
2008 Boilermaker J&J Gracious Professionalism Award
2007 St Louis Regional Winners
|