Thread: Drill motors
View Single Post
  #6   Spotlight this post!  
Unread 24-06-2002, 00:59
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
We can
Posted by Alex at 2/17/2001 8:57 AM EST


Engineer on team #405 from Richmond Community High and Infineon Technologies.


In Reply to: Drill motors
Posted by Nick on 2/16/2001 9:55 PM EST:



Our robot will do it. However, we are using a further gear reduction than just the low setting of the drill motor. Our robot uses a tank tread drive also.

Alex



: Does anyone think that two drill motors (with gear boxes in low gear) could drive a 130 robot + 2 goals full to the brim with balls? I think that is an estimated 300lbs.


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.