Thread: Wiring a potentiometer to the Analog Breakout
View Single Post
  #2   Spotlight this post!  
Unread 19-01-2009, 07:50
Russ Beavis Russ Beavis is offline
Registered User
no team
  
Join Date: Nov 2005
Location: Manchester, NH - DEKA R&D Corp.
Posts: 341
Russ Beavis has a reputation beyond reputeRuss Beavis has a reputation beyond reputeRuss Beavis has a reputation beyond reputeRuss Beavis has a reputation beyond reputeRuss Beavis has a reputation beyond reputeRuss Beavis has a reputation beyond reputeRuss Beavis has a reputation beyond reputeRuss Beavis has a reputation beyond reputeRuss Beavis has a reputation beyond reputeRuss Beavis has a reputation beyond reputeRuss Beavis has a reputation beyond repute
Re: Wiring a potentiometer to the Analog Breakout
Be VERY careful to wire the moving wiper to the signal pin on the Analog Breakout. If you do wire the wiper to either 5V or GND, you will short the power supply at one of the extremes. The power supply on the breakout should survive this but it will become very warm and all of the your sensors will lose power until the short is removed. Depending on the wiper and wire capability, you might even fry the wire and/or wiper.

Russ