View Single Post
  #20   Spotlight this post!  
Unread 19-01-2009, 13:02
Vikesrock's Avatar
Vikesrock Vikesrock is offline
Team 2175 Founder
AKA: Kevin O'Connor
no team
Team Role: Engineer
 
Join Date: Mar 2006
Rookie Year: 2007
Location: Manchester, NH
Posts: 3,305
Vikesrock has a reputation beyond reputeVikesrock has a reputation beyond reputeVikesrock has a reputation beyond reputeVikesrock has a reputation beyond reputeVikesrock has a reputation beyond reputeVikesrock has a reputation beyond reputeVikesrock has a reputation beyond reputeVikesrock has a reputation beyond reputeVikesrock has a reputation beyond reputeVikesrock has a reputation beyond reputeVikesrock has a reputation beyond repute
Send a message via AIM to Vikesrock Send a message via MSN to Vikesrock Send a message via Yahoo to Vikesrock
Re: pic: Ball Harvester

Quote:
Originally Posted by falconmaster View Post
Well we feel that we will be allowed with our bumper design. W willadd bumpers to the diagonal sections with 6 inch sections. If we are not allowed we will swap them out with a straight six inch sections. Our argument though will be that the corners will be protected, no bumper section will be less than 6 inches and the weight of the part not on the bumper perimeter will be counted against the robot weight. Even if you had a straight section instead of diagonals the corners would not be protected on the inside. Oh well we will see
Here's the problem with this. In order to protect the corner on the angled side the bumper will have to extend out past the corner itself placing it outside the bumper perimeter. With this being a bumper and not BUMPER it must fit within the volume constraints and would also redefine your bumper perimeter which would be problematic.
__________________


2007 Wisconsin Regional Highest Rookie Seed & Regional Finalists (Thanks 930 & 2039)
2008 MN Regional Semifinalists (Thanks 2472 & 1756)
2009 Northstar Regional Semifinalists (Thanks 171 & 525)
Reply With Quote