Thread: I NEED AN ANSWER!!! EVERYONE READ!
View Single Post
  #2   Spotlight this post!  
Unread 24-06-2002, 01:01
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: I NEED AN ANSWER!!! EVERYONE READ!
Posted by Elgin C at 2/17/2001 10:56 AM EST


Engineer on team #237, Sie-H20-Bots, from Watertown High School / NVCC.


In Reply to: I NEED AN ANSWER!!! EVERYONE READ!
Posted by Rob DeCotiis on 2/17/2001 9:18 AM EST:



: Can we use an angle bracket that's 4"?? would that be considered a joining plate for an extrusion or would it fall under steel angle in the additional hardware list???

There are limits on the size of angle you can use. It is somewhere in the Adittional Hardware list. Hope that helps.



__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.