Thread: RedB 2 Buck
View Single Post
  #3   Spotlight this post!  
Unread 24-06-2002, 01:03
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: RedB 2 Buck
Posted by Jim Meyer at 2/20/2001 9:19 AM EST


Engineer on team #67, HOT Team, from Huron Valley Schools and GM Milford Proving Ground.


In Reply to: RedB 2 Buck
Posted by greg on 2/18/2001 4:34 PM EST:



Have you tried a Unibit? In my experience they drill very fast, clean holes. We haven't drilled a lot of weight reduction holes with ours so I don't know how they hold up and I know ther are a little pricy, but in my opinion well worth it.

This would eliminate your coinage but maybe you could put a value on the weight of the chips?

Check out the link below if you haven't heard of a Unibit.
__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.