Thread: Brake/Coast Jumper
View Single Post
  #1   Spotlight this post!  
Unread 24-06-2002, 01:04
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Brake/Coast Jumper
Posted by Adrian Wong at 2/18/2001 11:42 PM EST


Student on team #596, Hopkinton Hillers, from Hopkinton High School and Zymark & Computer Associates.



Just a quick question..

On the Victor Speed Controllers, there are three pins for the Brake/Coast settings. Am I correct in saying that having the jumper connect to pins A and B will brake the motor and pins B and C will coast the motor?

I would test this myself on our robot, but all our motors are down in the machine shop getting modifications.

Thanks! (Too anxious for the Feb. 20 ship date, had to impulsively post this thread.)


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.