Thread: Brake/Coast Jumper
View Single Post
  #3   Spotlight this post!  
Unread 24-06-2002, 01:04
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: Brake/Coast Jumper
Posted by Josh Vetter at 2/19/2001 11:55 PM EST


Student on team #548, Robostangs, from Northville High School and BOSCH.


In Reply to: Re: Brake/Coast Jumper
Posted by Joe Ross on 2/19/2001 2:16 PM EST:



We haven't tried the brake at all, but there is a motor that we certainly could benefit from the use of it. I have a question about it though. If what it does is basically short the terminals, will it drain the battery?
Thanks
Josh Vetter

: : On the Victor Speed Controllers, there are three pins for the Brake/Coast settings. Am I correct in saying that having the jumper connect to pins A and B will brake the motor and pins B and C will coast the motor?

: Yes


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.