Thread: Strecher Problems!
View Single Post
  #4   Spotlight this post!  
Unread 24-06-2002, 01:06
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: Strecher Problems!
Posted by Jon - T190 at 2/19/2001 5:54 PM EST


Engineer on team #190, Gompei, from Mass Academy of Math and Science and Worcester Polytechnic Institute.


In Reply to: Strecher Problems!
Posted by Kyle Fenton on 2/19/2001 11:48 AM EST:



Don't forget... back in update 4 FIRST defined the minimal components to go on the stretcher...
GM25. The "minimum robot" that may be used on a stretcher must contain the following components:
-> Battery
-> Robot Controller
-> Radio
-> Rotating Light
-> Associated Wiring, Circuit Breakers, and Fuse Panel
-> Team Name/Number signs

Wouldn't it be neat if someone could separate those components into a light subsystem?

The SpiderGoat can...

: However getting back to the stretcher, if a team
: plans smartly, and only puts a metal bar or
: something light on the stretcher, and not their
: entire robot. It would be very possible to get us 10
: points.

: So the best solution, only use the stretcher when
: you have to. If you have to use the stretcher, take a
: spike or a metal bar from your robot, and strap it
: down with duct tape.



__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.