Thread: Traction for Balancers
View Single Post
  #3   Spotlight this post!  
Unread 24-06-2002, 01:06
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: Traction for Balancers
Posted by Anthony Lapp at 2/19/2001 3:39 PM EST


Engineer on team #221, MI Roboworks, from Michigan Technological University.


In Reply to: Traction for Balancers
Posted by Tyson Wormus on 2/19/2001 2:39 PM EST:



: What type of wheels are any of the teams planning to balance two bins using? I've looked at some of the pictures, and they look like standard wheelchair wheels. Our team had quite a bit of trouble with the traction of towing both goals up the ramp with standard wheels, we have since redesigned our wheels, but not without troubles. We are currently trying to figure out how not to shred the carpet. What types of wheels are you guys using?

we're on treads


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.