View Single Post
  #1   Spotlight this post!  
Unread 22-01-2009, 01:34
adamm adamm is offline
Registered User
AKA: Michael Adam
FRC #1671 (The Bird Brains)
Team Role: Mentor
 
Join Date: Mar 2007
Rookie Year: 2002
Location: Fresno, CA
Posts: 29
adamm is just really niceadamm is just really niceadamm is just really niceadamm is just really niceadamm is just really nice
Re: Issue with debugging/running code on cRio

My team ran across the same error you did at the beginning of the build season. The code would build in WindRiver, upload to the cRIO, and the DS would still read "No Code." I know our team was able to fix this issue, but I cannot remember what we did (Sorry). Make sure you have the updated version of LabVIEW or WindRiver and have flashed the cRIO with the correct firmware.

Also, try bypassing the wireless router/radio and plug port 1 on cRIO directly into port 1 on the DS and the computer to port 2 on the DS. There could be a chance that the radios are dropping packets, but its not likely.

I will ask around my team to see if they have any ideas or remember what we did.
__________________
Michael Adam
Director, Central Valley Robotics

FLL and FLL Jr. Affiliate Partner, Central California (2009-Present)
Member, Central Valley Regional Planning Committee (2012-Present)
Volunteer of the Year, Central Valley Regional (2015)
FRC Control System Advisor (2013-Present)
FRC Scorekeeper (2015-Present)
Mentor, Team 1671 (2009-Present)
Member, Team 1671 (2005-2009)