Quote:
Originally Posted by Bob Holmstrom
Bumper corners remain problematic. R08-N clearly states: "“Hard” parts of the BUMPER (i.e. plywood backing, fastening system, and clamping angles) may extend up to a maximum of one inch beyond the BUMPER PERIMETER." and then the figure 8.4 shows a ~3/4" extension as not ok!!
|
The N and O part of R08 refer to different directions...the hard part of the bumper may extend up to an inch out from the side the bumper is on, but may not extend past the end of that side past the corner at all.
http://www.chiefdelphi.com/forums/sh...ad.php?t=72260