Thread: LAST MINUTE Pneumatic Question
View Single Post
  #2   Spotlight this post!  
Unread 24-06-2002, 01:11
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Check the Manual...
Posted by Nate Smith at 2/20/2001 5:54 PM EST


Other on team #66, Frostbite, from Willow Run High School and GM Powertrain.


In Reply to: LAST MINUTE Pneumatic Question
Posted by Chris Orimoto on 2/20/2001 5:10 PM EST:



: Hey a few hours before shipping...

: Does anyone know of a way to wire the Double Solenoid
: Valve to ONE Spike Relay?
: A quick answer would be much appreciated...
: :-)

: Chris
: Team #36

If you look in the manual, it talks about using the diodes(also included in the kit) to write the double solenoid in such a way that you can use a single relay...OR, you could most likely(guessing here now) use the method that's in the manual for connecting two one-way items to a single relay...don't remember exactly where it is, but take a look...

Nate
__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.