Thread: LAST MINUTE Pneumatic Question
View Single Post
  #4   Spotlight this post!  
Unread 24-06-2002, 01:11
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Forget The Diodes
Posted by Bill Beatty at 2/21/2001 10:58 AM EST


Other on team #71, Team Hammond, from Team Hammond.


In Reply to: LAST MINUTE Pneumatic Question
Posted by Chris Orimoto on 2/20/2001 5:10 PM EST:



Chris

I recomend that you not use the diodes, but connect one wire from each solenoid to ground and the other wire from each solenoid to a output on the spike. This way the leds will both work on the valve and you don't have to fool with the diodes.

Mr Bill


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.