Thread: LAST MINUTE Pneumatic Question
View Single Post
  #6   Spotlight this post!  
Unread 24-06-2002, 01:11
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Yep...actually described in the manual (EOM)
Posted by Nate Smith at 2/21/2001 1:05 PM EST


Other on team #66, Frostbite, from Willow Run High School and GM Powertrain.


In Reply to: hmm...
Posted by GregT on 2/21/2001 11:59 AM EST:



: Is that legal?

: Greg

:
: : Chris

: : I recomend that you not use the diodes, but connect one wire from each solenoid to ground and the other wire from each solenoid to a output on the spike. This way the leds will both work on the valve and you don't have to fool with the diodes.

: : Mr Bill


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.