|
On the backside, away from the field we will be using L shaped angle aluminum brackets. This will allow us to fasten through the backboard reinforcement using one leg of the L, and then drill a hole and use a common fastener and nut through the other leg of the L on the angle brackets and divider board. This will allow us to keep the boards aligned and still construct it fairly easily. As far as the exact positioning of the backboard reinforcement, you are correct in guessing corner to end of shelving unit. The gap on the bottom that results will not be large enough to allow a juice bottle to fall through it - if yours is then slide the backboard reinforcement down that imaginary angle until the gap no longer allows a bottle to fall through.
|